control-tunnel cusp-agent

Function

The control-tunnel cusp-agent command binds a cusp-agent and creates a control channel between the vBRAS-UP and vBRAS-CP.

The undo control-tunnel cusp-agent command unbinds the cusp-agent and deletes the control channel created between the vBRAS-UP and vBRAS-CP.

By default,cusp-agent is not bound in the cu-agent view.

This command is supported only on the NetEngine 8000 F1A.

Format

control-tunnel cusp-agent agentname

undo control-tunnel cusp-agent [ agentname ]

Parameters

Parameter	Description	Value
agentname	Specifies the name of a cusp-agent.	The value is a string of 1 to 31 case-sensitive characters, spaces not supported.

Parameter

Description

Value

agentname

Specifies the name of a cusp-agent.

The value is a string of 1 to 31 case-sensitive characters, spaces not supported.

Views

CU-agent view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bras-control	write

Usage Guidelines

Usage Scenario

In the CUPS scenario, to bind a cusp-agent and create a control channel between the vBRAS-UP and vBRAS-CP, run the control-tunnel cusp-agent command.

This command is delivered by the vBRAS-CP to the vBRAS-UP.

Precautions

In VS mode, this command is supported only by the admin VS.

Example

# Display the configuration results on the UP side

[~HUAWEI] cu-agent
[~HUAWEI-cu-agent] display this
#
  cu-agent
   control-tunnel cusp-agent hw
#

# Bind the cusp-agent named huawei to the vBRAS-UP device and create a control channel between the vBRAS-UP and vBRAS-CP.Perform the configuration on the vBRAS-CP and vBRAS-UP.

<HUAWEI> sys
[~HUAWEI] cu-controller
[~HUAWEI-cu-controller] up 1024
[~HUAWEI-cu-controller-up1024] config
[~HUAWEI-cu-controller-up1024-config] cu-agent
[~HUAWEI-cu-controller-up1024-config-cu-agent] control-tunnel cusp-agent hw