cu-agent

Function

The cu-agent command enables the UP mode and displays the CU-agent view, or directly displays the CU-agent view.

The undo cu-agent command disables the UP mode.

By default, the UP mode is not enabled on the device.

This command is supported only on the NetEngine 8000 F1A.

Format

cu-agent

undo cu-agent

Parameters

None

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bras-control	write

Usage Guidelines

Usage Scenario

In the CUPS scenario, to enable the UP mode of a device so that the device functions as a vBRAS-UP, run the cu-agent command. In the UP mode, some CUPS channel commands must be run in the CU-agent view

Configuration Impact

After the UP mode is enabled, some commands of other features, such as the user access feature, are no longer supported. For details, see Commands Not Supported on the UP in Control and Forwarding-plane Separation Mode.

Precautions

In VS mode, this command is supported only by the admin VS.

If the device has been configured with multicast shaping or multicast virtual scheduling, this command cannot be used to enable the CU separation mode.

Example

# Enable the UP mode of a device and displays the CU-agent view.

<HUAWEI> system-view
[~HUAWEI] cu-agent
Warning: This command will configure the system to be CU mode, bras command can not take effect. Continue? [Y/N]:y
Info: This command will set the default configuration to invalid.