cu-mode

Function

The cu-mode command displays the CU-mode view and reports the specified interface to the vBRAS-CP for management.

The undo cu-mode command configures the interface not to be managed by the vBRAS-CP.

The cu-mode command identifies an SSL policy delivered by the vBRAS-CP.

By default, interfaces are not reported to the vBRAS-CP.

By default, this command is generated only for the SSL policy delivered by the vBRAS-CP.

This command is supported only on the NetEngine 8000 F1A.

Format

cu-mode

undo cu-mode

Parameters

None

Views

100GE interface view, 25GE interface view, 400GE interface view, Eth-Trunk interface view, GE electrical interface view, PW-VE interface view, VE interface view, Sub-interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bras-control	write

Usage Guidelines

Usage Scenario

In a CUPS scenario, after an SSL policy configured on the vBRAS-CP side is delivered to a vBRAS-UP, the cu-mode command is automatically generated to identify the SSL policy delivered by the vBRAS-CP.

This command is generated during SSL policy delivery by the vBRAS-CP and can be loaded properly during vBRAS-UP configuration restoration.

Precautions

The cu-mode command cannot be run on a sub-interface configured with network slicing.

Example

# Configure GE0/1/0 as a user interface of the UP and report the interface to the vBRAS-CP for management.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 1024/0/1/0
[~HUAWEI-GigabitEthernet1024/0/1/0] bas
[~HUAWEI-GigabitEthernet1024/0/1/0] access-type layer2-subscriber