cu-mode access-type

Function

The cu-mode access-type layer3 command reports an interface to the vBRAS-CP. The vBRAS-CP then manages the interface and sets the access mode of the interface to Layer 3 access.

The undo cu-mode access-type layer3 command deletes the configuration.

The cu-mode access-type layer3-leased-line command reports an interface to the vBRAS-CP. The vBRAS-CP then manages the interface and sets the access mode of the interface to Layer 3 leased access.

The undo cu-mode access-type layer3-leased-line command deletes the configuration.

By default, interfaces are not reported to the vBRAS-CP.

This command is supported only on the NetEngine 8000 F1A.

Format

cu-mode access-type layer3

cu-mode access-type layer3-leased-line

undo cu-mode access-type layer3

undo cu-mode access-type layer3-leased-line

Parameters

None

Views

100GE interface view, 25GE interface view, 400GE interface view, Eth-Trunk interface view, GE electrical interface view, PW-VE interface view, VE interface view, Sub-interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bras-control	write

Usage Guidelines

In the CU separation scenario, the BRAS service needs to be configured on the vBRAS-CP and delivered to the vBRAS-UP. After the access-type layer3-subscriber or access-type layer3-leased-line command is run in the BAS interface view on the vBRAS-CP, the cu-mode access-type layer3 or cu-mode access-type layer3-leased-line command is delivered to the corresponding interface on the vBRAS-UP. When the access-type layer3-subsvriber or access-type layer3-leased-line command is deleted from the BAS interface view on the vBRAS-CP, the cu-mode access-type layer3 or cu-mode access-type layer3-leased-line command is deleted from the corresponding interface on the vBRAS-UP.

Example

# Display the configuration results on the UP side

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 0/1/17
[~HUAWEI-GigabitEthernet0/1/17] display this
[~HUAWEI-GigabitEthernet0/1/17]
#
interface GigabitEthernet0/1/17
 undo shutdown
 cu-mode access-type layer3
#

# Configure GE1024/0/1/17 as a user interface of a vBRAS-UP and report the interface to the vBRAS-CP for management. Perform the configuration on the vBRAS-CPand Check the configuration on the vBRAS-UP.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 1024/0/1/17
[~HUAWEI-GigabitEthernet1024/0/1/17] bas
[~HUAWEI-GigabitEthernet1024/0/1/17] access-type layer3-subscriber