display transfer-mode

Function

The display transfer-mode command displays the transfer mode of a 10 GE LAN/WAN interface.

This command is supported only on the NetEngine 8000 F1A.

Format

display transfer-mode

Parameters

None

Views

10G LAN interface view, 10G WAN interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
device-mgr	write

Usage Guidelines

Usage Scenario

The interfaces at both ends of a 10GE LAN/WAN link must have the same transfer mode. To check the transfer mode of a 10GE LAN/WAN interface, run the display transfer-mode command. The command output helps locate faults and analyze problems.

Example

The actual command output varies according to the device. The command output here is only an example.

# Display the transmission mode of the GE0/1/1 interface.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet0/1/1
[~HUAWEI-GigabitEthernet0/1/1] display transfer-mode
 Info: Transfer-mode is LAN

**Table 1** Description of the **display transfer-mode** command output
Item	Description
Info	The transfer mode of an interface is LAN or WAN.