emdi channel outbound

Function

The emdi channel outbound command binds an EMDI channel to the outbound interface.

The undo emdi channel outbound command unbinds an EMDI channel from the outbound interface.

By default, an EMDI channel is not bound to the outbound interface.

This command is supported only on the NetEngine 8000 F1A.

Format

emdi channel channel-name outbound

undo emdi channel channel-name outbound

Parameters

Parameter	Description	Value
channel-name	Specifies the name of a channel.	The value is a string of 1 to 31 case-sensitive characters, spaces not supported.

Parameter

Description

Value

channel-name

Specifies the name of a channel.

The value is a string of 1 to 31 case-sensitive characters, spaces not supported.

Views

Eth-Trunk sub-interface view, Eth-Trunk interface view, FlexE sub-interface view, FlexE interface view, GE interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
emdi	write

Usage Guidelines

Usage Scenario

When the downstream EMDI detection solution is used, after the EMDI channels and boards to be detected are configured and the EMDI channel group is bound to the EMDI board group, run the emdi channel outbound command to bind an EMDI channel to the outbound interface to detect indicators of the EMDI channel in the downstream direction.

Prerequisites

An EMDI channel group has been created using the emdi channel-group command. An EMDI board group has been created using the emdi lpu-group command. The EMDI channel group has been bound to the EMDI board group using the emdi bind channel-group lpu-group outbound command.

Precautions

An EMDI channel can be bound to only one interface on a board. A maximum of 20 EMDI channels can be bound to an interface.

Example

# Bind EMDI channel 1 to the outbound interface.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet0/1/8
[~HUAWEI-GigabitEthernet0/1/8] emdi channel 1 outbound