emdi rtp-jitter enable
Function
The emdi rtp-jitter enable command enables jitter detection.
The undo emdi rtp-jitter enable command disables jitter detection.
By default, jitter detection is disabled.
This command is supported only on the NetEngine 8000 F1A.
Usage Guidelines
Usage Scenario
By default, the EMDI detection solution detects only the packet loss rate and packet disorder rate. In some scenarios, the jitter indicator also needs to be detected. To enable jitter detection, run the emdi rtp-jitter enable command.
Precautions
On some specified network, after jitter detection is enabled, the jitter along with the packet loss rate and packet disorder rate are periodically sent to the uTraffic. On other network, after jitter detection is enabled, a device detects the jitter indicator but does not report the detection indicator data to the uTraffic.