emdi monitor-rate-only

Function

The emdi monitor-rate-only command enables detection only on the rate of video streams.

The undo emdi monitor-rate-only command disables detection only on the rate of video streams.

By default, detection only on the rate of video streams is disabled.

This command is supported only on the NetEngine 8000 F1A.

Format

emdi monitor-rate-only

undo emdi monitor-rate-only

Parameters

None

Views

EMDI view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
emdi	write

Usage Guidelines

Usage Scenario

On the NG-MVPN, if the transit and bud nodes overlap, two pieces of traffic will be detected on the same node, causing offset in the detection results of the packet loss rate, packet disorder rate, and jitter. To avoid detection offset when the transit and bud nodes overlap and ensure the accuracy of detection results, run the emdi monitor-rate-only command to enable EMDI detection only on the rate of video streams that pass through the node instead of the packet loss rate, packet disorder rate, and jitter.

Example

# Enable detection only on the rate of video streams.

<HUAWEI> system-view
[~HUAWEI] emdi
[~HUAWEI-emdi] emdi monitor-rate-only