https-redirect

Function

The https-redirect command is used to enable the function of sending HTTPS packets to Interface board.

The undo https-redirect command is used to disable the function of sending HTTPS packets to Interface board.

By default, the function to send HTTPS packets is not enabled.

This command is supported only on the NetEngine 8000 F1A.

Format

https-redirect

undo https-redirect

Parameters

None

Views

Traffic behavior view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
portal	write

Usage Guidelines

Usage Scenario

During web user redirection, the https-redirect command must be run in the traffic behavior view to allow user packets that match the ACL rule with the destination port number of 443 to be sent to an interface board. This command must be used together with the access https-redirect command to implement the HTTPS redirection function.

Prerequisites

Before the https-redirect command is run to redirect online users to the authentication page, ensure that the basic configuration of user login is complete.

Follow-up Procedure

When using traffic classification to define a redirection web page, run the rule command to configure the advanced ACL rule to match the destination port number (443) associated with the HTTPS address.

Precautions

The policy-based routing and BRAS redirection are mutually exclusive in one traffic behavior.
In VS mode, this command is supported only by the admin VS.

Example

# Enable the function of sending HTTPS packets

<HUAWEI> system-view
[~HUAWEI] traffic behavior b1
[*HUAWEI-behavior-b1] https-redirect