ip pool(System view)

Function

The ip pool command creates an IP address pool.

The undo ip pool command removes an IP address pool.

By default, no address pool is created.

This command is supported only on the NetEngine 8000 F1A.

ip pool ip-pool-name

undo ip pool ip-pool-name

Parameter	Description	Value
ip-pool-name	Specifies the name of the IP address pool. It can contain the following characters: Letters A-Z or a-z. Digits 0-9. . - or _. The name of the IP address pool includes only the character of - or - - is not supported.	The value is a string of 1 to 128 case-insensitive characters.

System view

2: Configuration level

Task Name	Operations
ippool	write

Usage Scenario

If a device is deployed to assign IP addresses to users, run the command to create an address pool.

Precautions

In VS mode, this command is supported only by the adminVS.

If the IP address pool contains any IP address that is occupied or referenced by a domain, you cannot remove the IP address pool.

The address pools of all types cannot have the same name.

A maximum of 4096 IP address pools of all types can be configured.

# Enter the address pool view named Huawei.

<HUAWEI> system-view
[~HUAWEI] ip pool huawei