mld lastlistener-queryinterval

Format

mld lastlistener-queryinterval interval

undo mld lastlistener-queryinterval

Parameters

Parameter	Description	Value
interval	Specifies the interval for sending MLD last-listener query messages.	The value is an integer ranging from 1 to 25, in seconds.

Parameter

Description

Value

interval

Specifies the interval for sending MLD last-listener query messages.

The value is an integer ranging from 1 to 25, in seconds.

Views

100ge sub-interface view, 100GE interface view, 10GE sub-interface view, 10GE interface view, 200GE sub-interface view, 25GE sub-interface view, 25GE interface view, 400GE sub-interface view, 400GE interface view, 40GE sub-interface view, 40GE interface view, 50GE sub-interface view, 50GE interface view, Eth-Trunk sub-interface view, Eth-Trunk interface view, FlexE interface view, GE optical interface view, GE sub-interface view, GE interface view, GE electrical interface view, Global VE sub-interface view, Loopback interface view, PW-VE sub-interface view, VE sub-interface view, VLANIF interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
igmp	write

Usage Guidelines

Usage Scenario

After receiving an MLD Leave message from a host, the MLD querier immediately starts the Query message timer. If the querier does not receive any Reply message from the host within a specified timer period, the querier determines that the host leaves the MLD group. You can run this command to set a period for the Query message timer.

Example

# Set the interval for sending last-listener query messages to 3 seconds on GE 0/1/0.

<HUAWEI> system-view
[~HUAWEI] multicast ipv6 routing-enable
[*HUAWEI] interface GigabitEthernet 0/1/0
[*HUAWEI-GigabitEthernet0/1/0] ipv6 enable
[*HUAWEI-GigabitEthernet0/1/0] mld lastlistener-queryinterval 3