mode channel bandwidth

Function

The mode channel bandwidth command configures bandwidth for a channelized sub-interface.

The undo mode channel bandwidth command restores the default bandwidth of a channelized sub-interface.

By default, the bandwidth of a channelized sub-interface is 2 Mbit/s.

Format

mode channel bandwidth bwvalue

undo mode channel bandwidth bwvalue

Parameters

Parameter	Description	Value
bwvalue	Specifies the bandwidth value of a channelized sub-interface.	The value is an integer that ranges from 2 to 1000000000, in Mbit/s.

Parameter

Description

Value

bwvalue

Specifies the bandwidth value of a channelized sub-interface.

The value is an integer that ranges from 2 to 1000000000, in Mbit/s.

Views

Sub-interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
forwarding	write

Usage Guidelines

Usage Scenario

To configure bandwidth for a channelized sub-interface, run the mode channel bandwidth command.

Precautions

For the port supporting CM mode, the available bandwidth of channelized sub interface can only be configured after the RTU of the port is activated and the bandwidth is effective.

Example

# Set the bandwidth of the channelized sub-interface GE 0/1/0.10 to 200 Mbit/s.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet0/1/0.10
[~HUAWEI-GigabitEthernet0/1/0.10] vlan-type dot1q 10
[*HUAWEI-GigabitEthernet0/1/0.10] mode channel enable
[*HUAWEI-GigabitEthernet0/1/0.10] mode channel bandwidth 200