mode channel enable

Function

The mode channel enable command enables channelization on a sub-interface.

The undo mode channel enable command disables channelization on a sub-interface.

By default, channelization is not enabled on a sub-interface.

Format

mode channel enable

undo mode channel enable

Parameters

None

Views

Sub-interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
forwarding	write

Usage Guidelines

Usage Scenario

In network slicing scenarios, to enable channelization on a sub-interface of an Ethernet physical interface, run the mode channel enable command. This configuration creates a channelized sub-interface and implements independent HQoS rate limiting.

Prerequisites

The encapsulation mode of a sub-interface has been set to dot1q using the vlan-type dot1q vlan-id command.

To activate the port slicing license in batches on the device, run theactive port-slicing command.

There is no need to activate the license for a channelized sub-interface on a GE interface.

Precautions

Channelization of a sub-interface is mutually exclusive with a BRAS service.

Channelization of a sub-interface is mutually exclusive with MPLS TE tunnel traffic policing.

Channelization of a sub-interface is mutually exclusive with VPN QoS tunnel traffic policing.

Channelization of a sub-interface is mutually exclusive with interface HQoS traffic policing.

Channelization of a sub-interface is mutually exclusive with PIM SIM service.

Example

# Enable channelization on GE 0/1/0.10.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet0/1/0.10
[*HUAWEI-GigabitEthernet 0/1/0.10] vlan-type dot1q 10
[*HUAWEI-GigabitEthernet 0/1/0.10] mode channel enable