multicast-nat enable

Function

The multicast-nat enable command enables multicast NAT globally.

The undo multicast-nat enable command disables multicast NAT globally and deletes all multicast NAT configurations.

By default, multicast NAT is disabled globally.

This command is supported only on the NetEngine 8000 F1A.

Format
Parameters
Views
Default Level
Task Name and Operations
Usage Guidelines
Example

Format

multicast-nat enable

undo multicast-nat enable

Parameters

None

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
forwarding	write

Usage Guidelines

Usage Scenario

Before translating an input multicast stream into output multicast streams with different characteristics (source IP address, destination IP address, and destination port number), you must run the multicast-nat enable command to enable multicast NAT globally.

Precautions

This command is supported only in the admin VS.

Example

# Enable multicast NAT globally.

<HUAWEI> system-view
[~HUAWEI] multicast-nat enable