nat64 user-session create-rate

Function

The nat64 user-session create-rate command sets the rate at which packets are sent to create a flow on a NAT64 device.

The undo nat64 user-session create-rate command restores the default rate.

By default, the rate at which packets are sent to create a flow is 6 kpps.

This command is supported only on the NetEngine 8000 F1A.

Format

nat64 user-session create-rate rate

undo nat64 user-session create-rate [ rate ]

Parameters

Parameter	Description	Value
rate	Specifies the rate at which packets are sent to create a flow on a NAT64 device.	The value is an integer ranging from 1 to 64, in kilo packets per second.

Parameter

Description

Value

rate

Specifies the rate at which packets are sent to create a flow on a NAT64 device.

The value is an integer ranging from 1 to 64, in kilo packets per second.

Views

NAT64 instance view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
nat	write

Usage Guidelines

Usage Scenario

To set the rate at which packets are sent to create a flow on a NAT64 device, run the nat64 user-session create-rate command. If the rate at which packets are sent exceeds the configured rate, excess packets are discarded.

Prerequisites

A NAT64 instance has been created, and the NAT64 session number limit function has been enabled. By default, the limit function is enabled.

Example

# Enables a user to create user flows at 32 kpps in a NAT64 instance named nat1.

<HUAWEI> system-view
[~HUAWEI] nat64 instance nat1 id 1
[*HUAWEI-nat64-instance-nat1] nat64 user-session create-rate 32