nd-proxy enable

Function

The nd-proxy enable command enables proxy ND on a BAS interface.

The undo nd-proxy enable command disables proxy ND on a BAS interface.

By default, proxy ND is disabled on a BAS interface.

This command is supported only on the NetEngine 8000 F1A.

Format

nd-proxy enable

undo nd-proxy enable

Parameters

None

Views

BAS interface view (GE), BAS interface view (VE), BAS interface view (trunk)

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
nd	write

Usage Guidelines

Usage Scenario

Proxy ND enables IPv6 users on the same BRAS interface to access each other. Users on the same BRAS interface of the device are isolated by VLANs and cannot directly communicate. To enable the users to access each other, you must enable proxy ND on the BAS interface.

Proxy ND can be enabled on only the BAS interface whose access type is set as Layer 2 access.

Proxy ND is always enabled for users on different interfaces and VLANs.

Precautions

In VS mode, this command is supported only by the admin VS.

Example

# Enable proxy ND on the BAS interface GE 0/1/1.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 0/1/1
[~HUAWEI-GigabitEthernet0/1/1] commit
[~HUAWEI-GigabitEthernet0/1/1] bas
[~HUAWEI-GigabitEthernet0/1/1-bas] access-type layer2-subscriber
[*HUAWEI-GigabitEthernet0/1/1-bas] commit
[~HUAWEI-GigabitEthernet0/1/1-bas] nd-proxy enable