| Parameter | Description | Value |
|---|---|---|
| vsi-name |
Specifies the name of a VSI. |
The value is a string of 1 to 31 case-sensitive characters, spaces not supported. When double quotation marks are used around the string, spaces are allowed in the string. |
| peer peer-address |
Specifies a peer IP address. |
The value is in dotted decimal notation. |
| negotiation-vc-id vc-id |
Specifies a VC ID. |
The value is an integer ranging from 1 to 4294967295. |
| ldp129 |
Indicates the LDP FEC 129 signaling. |
- |
| remote-site remote-site-id |
Specifies a remote site ID. |
The value is an integer ranging from 0 to 65534. |
Usage Scenario
The display traffic-statistics vsi command allows you to check VPLS PW traffic statistics. To check VPLS PW traffic statistics collected within a specific period of time, you need to clear the previous traffic statistics by running the reset traffic-statistics vsi peer command.
Depending on the signaling protocol used by VPLS, traffic statistics collection on VPLS networks can be collected in either LDP or BGP-AD mode. Therefore, you can set the parameter in this command based on the VPLS signaling protocol.Prerequisites
The traffic-statistics enable or traffic-statistics peer command must have been run in the VSI-LDP view, if you want to checkLDP VPLS PW traffic statistics.
Configuration Impact
After the reset traffic-statistics vsi peer command is run, all the previous statistics on the specified PW are cleared.