reset delayed-release ip-address
Function
The reset delayed-release ip-address command reclaims a specified IP address that is in the delayed release state, or the IP addresses that are in the delayed release state in a specified address segment of an IP address pool.
This command is supported only on the NetEngine 8000 F1A.
Parameters
| Parameter | Description | Value |
|---|---|---|
| start-ip-address |
Specifies the start IP address that is in the delayed release state. |
The value is in the dotted decimal format. |
| end-ip-address |
Specifies the end IP address that is in the delayed release state. If you do not specify this parameter, only one IP address is reclaimed. |
The value is in the dotted decimal format. |
Usage Guidelines
Usage Scenario
After the access ip-address delayed-release time command is run to configure a delay for IP address release, most IP addresses may be in the delayed release state. As a result, users cannot go online within a period of time. To resolve this issue or reclaim the IP addresses that are in the delayed release state as required, run the** reset delayed-release ip-address** command.
NOTE: This command can be run only in the view of a local, RUI-slave, dynamic, or server address pool.Precautions
In VS mode, this command is supported only by the admin VS.
Example
<HUAWEI> system-view [~HUAWEI] ip pool huawei bas local Info: It's successful to create an IP address pool [*HUAWEI-ip-pool-huawei] commit [~HUAWEI-ip-pool-huawei] reset delayed-release ip-address 192.168.1.2 192.168.1.10