session cdn send delay

Function

The session cdn send delay command configures the device to send CDN messages only after receiving LCP termination ack messages in response to the LCP termination request messages it sends.

The undo session cdn send delay command restores the default configuration.

By default, the device sends LCP termination request messages and CDN messages at the same time.

This command is supported only on the NetEngine 8000 F1A.

Format

session cdn send delay

undo session cdn send delay

Parameters

None

Views

L2TP group view

Default Level

2: Configuration level

Task Name and Operations

Task Name Operations
l2tp write

Usage Guidelines

If the interconnected LAC requires the device to send CDN messages only after the device receives LCP termination ack messages, run the session cdn send delay command.

Example

# Configure the device that functions as an LNS to send CDN messages only after receiving LCP termination ack messages in response to the LCP termination request messages it sends.
<HUAWEI> system-view
[~HUAWEI] interface virtual-template 1
[~HUAWEI-Virtual-Template1] commit
[~HUAWEI-Virtual-Template1] quit
[~HUAWEI] l2tp-group huawei
[*HUAWEI-l2tp-huawei] allow l2tp virtual-template 1 remote lac1
[*HUAWEI-l2tp-huawei] session cdn send delay
Parent Topic: L2TP Access Configuration Commands
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic Next topic >