set transfer-mode (interface view)

Function

The set transfer-mode command sets the transmission mode of the interface to LAN or WAN.

The undo set transfer-mode command restores the default transmission mode.

By default, the transmission mode of the interface is LAN.

This command is supported only on the NetEngine 8000 F1A.

Format

set transfer-mode wan

set transfer-mode lan

undo set transfer-mode

Parameters

Parameter	Description	Value
lan	Indicates that the transmission mode of an interface is LAN.	-
wan	Indicates that the transmission mode of an interface is WAN.	-

Parameter

Description

Value

lan

Indicates that the transmission mode of an interface is LAN.

wan

Indicates that the transmission mode of an interface is WAN.

Views

10G LAN interface view, 10G WAN interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
device-mgr	write

Usage Guidelines

Usage Scenario

If transmission modes of interfaces at two ends of a link do not match (for example, one is in LAN mode and the other is in WAN mode), run the set transfer-mode command to configure one interface to work in the same transmission mode as the other to ensure reliable transmission.

Prerequisites

Before setting the transmission mode of a 10GE interface to LAN or WAN, delete the clock, PTP, and loopback configurations from the interface and run the shutdown command on the interface.

In VS mode, this command is supported only by the admin VS.

Example

# Set the transmission mode of 10GE LAN/WAN interface GE 0/1/1 to WAN.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 0/1/1
[~HUAWEI-GigabitEthernet0/1/1] shutdown
[*HUAWEI-GigabitEthernet0/1/1] set transfer-mode wan
[*HUAWEI-GigabitEthernet0/1/1] undo shutdown