statistic enable mode port

Function

The statistic enable mode port command enables bit rate statistics collection on an Ethernet interface. The statistics include bit rates (in bps) of multicast, unicast, and broadcast traffic.

The undo statistic enable mode port command disables bit rate statistics collection on an Ethernet interface.

By default, bit rate statistics collection is disabled on Ethernet interfaces.

Format

statistic enable mode port

undo statistic enable mode port

Parameters

None

Views

100GE interface view, 10G LAN interface view, 10G WAN interface view, 25GE interface view, 400GE interface view, 40GE interface view, Eth-Trunk interface view, FlexE-50G interface view, FlexE-50|100G interface view, FlexE interface view, GE optical interface view, GE interface view, GE electrical interface view, Management interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
forwarding	write

Usage Guidelines

Usage Scenario

By default, bit rate statistics collection is disabled on Ethernet interfaces. Before checking the bit rate statistics about packets received and sent by an Ethernet interface, run the statistic enable mode port command in the Ethernet interface view to enable bit rate statistics collection. The bit rate statistics of multicast, unicast, and broadcast traffic can be distinguished based on destination MAC addresses.

Prerequisites

Bit rate statistics collection has been supported on the boards where Eth-Trunk member interfaces or physical interfaces reside.

Follow-up Procedure

Run the display counters rate command to check the statistics.

Example

# Enable bit rate statistics collection on GE 0/1/0.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 0/1/0
[~HUAWEI-GigabitEthernet0/1/0] statistic enable mode port