traffic-policy network inbound

Function

The traffic-policy network inbound command applies a traffic policy to a VPN instance.

The undo traffic-policy network inbound command cancels the configuration.

By default, a traffic policy is not applied to a VPN instance.

Format

traffic-policy policy-name network inbound

undo traffic-policy network inbound

undo traffic-policy policy-name network inbound

Parameters

Parameter	Description	Value
policy-name	Applies a traffic policy to a VPN instance.	The value is a string of 1 to 127 case-sensitive characters.
inbound	Applies a traffic policy to upstream traffic.	-

Parameter

Description

Value

policy-name

Applies a traffic policy to a VPN instance.

The value is a string of 1 to 127 case-sensitive characters.

inbound

Applies a traffic policy to upstream traffic.

Views

VPN instance view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
qos	write

Usage Guidelines

Usage Scenario

When IP addresses of VPNs are the same, upstream traffic on the MPLS-side interface of the MPLS tunnel egress cannot be classified based on VPN and IP address information, causing traffic directing problems. To address this issue, run the traffic-policy network inbound command to apply a traffic policy to a VPN instance.

L3VPN traffic policies are not supported in Carrier Supporting Carrier (CSC) scenarios.

Example

# Apply the traffic policy named p1 to the VPN instance named vpn1.

<HUAWEI> system-view
[~HUAWEI] traffic policy p1
[*HUAWEI-trafficpolicy-p1] quit
[*HUAWEI] ip vpn-instance vpn1
[*HUAWEI-vpn-instance-vpn1] traffic-policy p1 network inbound