tunnel-selector (BGP-IPv4 unicast address family view/BGP view)

Function

The tunnel-selector command applies a tunnel selector.

The undo tunnel-selector command deletes the configuration.

By default, no tunnel selector is applied to BGP-VPNv4, BGP-VPNv6 or labeled BGP routes. BGP-VPNv4, BGP-EVPN routes, BGP-VPNv6 or labeled BGP routes recurse only to LSPs.

Format

tunnel-selector tunnel-selector-name all

tunnel-selector tunnel-selector-name

undo tunnel-selector

Parameters

Parameter	Description	Value
tunnel-selector-name	Specifies the name of a tunnel selector.	The value is a string of 1 to 40 case-sensitive characters, spaces not supported. When double quotation marks are used around the string, spaces are allowed in the string.
all	The tunnel selector applies to all BGP IPv4 unicast routes, including labeled routes, imported routes, and network segment routes.	-

Parameter

Description

Value

tunnel-selector-name

Specifies the name of a tunnel selector.

The value is a string of 1 to 40 case-sensitive characters, spaces not supported. When double quotation marks are used around the string, spaces are allowed in the string.

all

The tunnel selector applies to all BGP IPv4 unicast routes, including labeled routes, imported routes, and network segment routes.

Views

BGP-IPv4 unicast address family view, BGP view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bgp	write

Usage Guidelines

Usage Scenario

On a BGP/MPLS IP VPN, run the tunnel-selector command to apply a tunnel selector to BGP routes so that these routes can recurse to desired types of tunnels in the following situations:

The ASBR in inter-AS VPN Option B networking needs to apply a tunnel policy to BGP routes that are received from PEs, although VPN instances are not configured on the ASBR.
The SPE in the HoVPN networking needs to apply a tunnel policy to VPNv4 routes that are received from UPEs.
The PE in inter-AS VPN Option C networking needs to apply a tunnel policy to recurse labeled routes to TE tunnels to guarantee bandwidth or implement load balancing among BGP LSPs.
In an inter-AS VPN Option C scenario, to implement tunnel-based load-balancing among labeled BGP routes, run the tunnel-selector [all] command to configure a tunnel selector on the ASBR. If the all parameter is used, the tunnel selector applies to all BGP IPv4 unicast routes, including labeled routes, imported routes, and network segment routes.

Prerequisites

A tunnel selector has been configured using the tunnel-selector (system view) command.

Precautions

The SRv6 TE Policy or SRv6 TE Policy Group of tunnel is not supported in a tunnel selector specified in the command.

Example

# Apply a tunnel selector to BGP routes.

<HUAWEI> system-view
[~HUAWEI] tunnel-selector tps permit node 10
[*HUAWEI-tunnel-selector] quit
[*HUAWEI] bgp 100
[*HUAWEI-bgp] ipv4-family unicast
[*HUAWEI-bgp-af-ipv4] tunnel-selector tps