The destination command configures a destination address for a tunnel.
The undo destination command deletes the destination address of a tunnel.
By default, no destination address is configured for a tunnel.
destination ip-address
undo destination
Specifies the destination address of a tunnel.
The value is in dotted decimal notation.
Tunnel interface view
2: Configuration level
Usage Scenario
When configuring the tunnels, you need to create tunnel interfaces and use the destination command to configure the destination addresses of tunnels.
Prerequisites
The tunnel mode has been configured using the tunnel-protocol command.
<HUAWEI> system-view [~HUAWEI] interface Tunnel 10 [*HUAWEI-Tunnel10] tunnel-protocol ipv6-ipv4 [*HUAWEI-Tunnel10] destination 2.2.2.2