user-group-queue (bas interface view)
Function
The user-group-queue command configures a user group queue for a BAS interface.
The undo user-group-queue command deletes a user group queue from a BAS interface.
By default, no user group queue is configured for a BAS interface.
This command is supported only on the NetEngine 8000 F1A.
Parameters
| Parameter | Description | Value |
|---|---|---|
| outbound |
Configures a user group queue for an outbound BAS interface. |
- |
| group group |
Specifies the name of a user group. |
The value is a string of 1 to 31 case-sensitive characters, spaces not supported. |
| user-group-queue user-group-queue-name |
Specifies the name of a user group queue profile. |
The value is a string of 1 to 31 case-sensitive characters, spaces not supported. |
Usage Guidelines
Usage Scenario
HQoS uses multi-level scheduling to distinguish user-specific or service-specific traffic and provide differentiated bandwidth management. When the traffic rate of the upstream device exceeds the capability of the downstream device and bandwidth insufficiency and network congestion occur, configure a user group queue on the BAS side to implement bandwidth management.
Prerequisites
Before running the command to assign a user group queue to a BAS interface, ensure that the user group queue has been created using the user-group-queue <group-name> command in the system view and that access-type is set to a Layer 2 subscriber or Layer 3 subscriber interface in the BAS interface view.
Example
<HUAWEI> system-view [~HUAWEI] user-group-queue test [*HUAWEI-user-group-queue-test] quit [*HUAWEI] interface GigabitEthernet 0/1/7 [*HUAWEI-GigabitEthernet0/1/7] bas [*HUAWEI-GigabitEthernet0/1/7-bas] access-type layer2-subscriber [*HUAWEI-GigabitEthernet0/1/7-bas] user-group-queue test outbound