debugging dhcpv6 access packet
Function
The debugging dhcpv6 access packet command enables the debugging of a DHCPv6 access module.
The undo debugging dhcpv6 access packet command disables the debugging of a DHCPv6 access module.
By default, the debugging of a DHCPv6 access module is disabled.
This command is supported only on the NetEngine 8000 F1A.
Usage Guidelines
Usage Scenario
The debugging dhcpv6 access packet command is used to enable the debugging of a DHCPv6 access module to view its procedure and exchange information.
Configuration Impact
Debugging affects system performance. After debugging is complete, disable debugging immediately.
Precautions
In VS mode, this command is supported only by the admin VS.