The debugging bgp packet update mdt command enables debugging of BGP-MDT packets.
The undo debugging bgp packet update mdt command disables debugging of BGP-MDT packets.
By default, debugging of BGP packets is disabled.
| Parameter | Description | Value |
|---|---|---|
| peer peerIpv4Addr |
Specifies the IP address of an IPv6 peer. |
The value is a 32-digit hexadecimal number, in the format of X:X:X:X:X:X:X:X. |
| receive |
Outputs debugging information about the specified packet receiving direction. |
- |
| send |
Outputs debugging information about the specified packet sending direction. |
- |
Usage Scenario
The debugging bgp packet command enables debugging of BGP packets so that you can view the information during BGP packet receiving and sending.
When much information is output, you can filter the output information by VPN instance, peer, and address family.Follow-up Procedure
Run the undo debugging bgp packet command to disable debugging.
Precautions
Debugging information is output on the screen. Do not output too much information for other purposes than debugging so that the performance is not affected.