Attaching the Cabinets and Restoring the ESD Floor

Installing the connection plates.
1. Remove the connection plates on the lintels of the front and rear doors and install them again as shown in the figure.
  Figure 1 Installing the connection plates
2. Use the spirit level and the plumb line to verify that the bottom line of the cabinet is horizontal and the front line of the column is vertical. If the cabinet is not horizontal, adjust the adjusting anchor by using a socket wrench.
  Figure 2 Leveling the cabinet
  
  Both the gap between cabinets and the vertical deviation should be no less than 3 mm.
Restoring the ESD floor.
Figure 3 Restoring the ESD floor

The ESD floor has been removed before you determine the installation position of the supports. Cut the ESD floor according to the size of the cabinet.

For underfloor cabling, place the cables before you restore the ESD floor.