BRASAM/6/AMV6_LOG_ISOLATE_PREFIX
Message
BRASAM/6/AMV6_LOG_ISOLATE_PREFIX: The IPv6 prefix was automatically locked due to address allocation failures. (PrefixName=[PrefixName])
This log is supported only on NetEngine 8000 F1A.
In VS mode, this log is supported only by the admin VS.
Possible Causes
The number of times IPv6 address allocation from the prefix pool fails exceeds 50, and the prefix pool was automatically locked.
Procedure
1. Run the clear auto-block ipv6-prefix command in the diagnostic view to unlock the address pool.
- If the fault persists, go to Step 2.
- If the fault is rectified, go to Step 3.
2. Collect alarm, log, and configuration information, and contact technical support personnel.
3. End.