L2VPN/4/BoardServiceMismatchEvent

Message

L2VPN/4/BoardServiceMismatchEvent: The board does not support the service.(EntityPhysicalIndex= [EntityPhysicalIndex], ServiceID =[ServiceID], EntPhysicalName= [EntPhysicalName], ServiceName = [ServiceName], Precautions =[Precautions]).

Description

The entity does not support this service. (Entity Index = [EntityPhysicalIndex], Service ID = [ServiceID], Entity Name = [EntPhysicalName], Business Name = [ServiceName], Attention Actions = [Precautions]).

Parameters

Parameter Name	Parameter Meaning
EntityPhysicalIndex	Entity index.
ServiceID	the service ID, the current range is .
EntPhysicalName	Entity name.
ServiceName	Service name. 1: VPLS E-TREE 2: VPLS TPID 3: VLL TPID 4: VPLS FLOWLABEL 5: VLL FLOWLABEL 6: VPLS CONTROLWORD 7: NG-MVPN 8: MP2MP_PBB_VPLS 9: QOS_DS 10: TE HQOS 11: SOFTGRE 12: P2P_PBB_VPLS 13: LTICAST LSP 14: ETHTRUNK_CONTROL 16: ICB Bypass PW 17: VPLS_SHORT_PIPE 18: QOS_URPF 19: IVL 20: QOS_VSIACL 21: LDP_STATISTIC 28: VEMAC_UPDATEDISABLE 29: VXLAN 30: QOS_GTPACL 31: L2TPV3 32: VPLSPW PACKET-TYPE STATISTIC 33: VCPE 34: CFM_Sender_id_TLV 35: NvTrafficReplication 49: TWAMP_Light
Precautions	Note, the specific situation, such as: 19: Note that the IVL configured cannot reside on a board in this slot. If such a board is used, the VSI fails to take effect. 40: Note that the VRRP6 configured cannot reside on the board. If such a board is used, the VRRP6 fails to take effect. 42: Note that the MLDP configured cannot reside on a board in this slot. If such a board is used, the MLDP fails to take effect. 43: Note that SR-MPLS TE TI-LFA FRR may not take effect if this board is installed. 44: Note that the POPGO configured cannot reside on a board in this slot. If such a board is used, the POPGO may not to take effect 45: Note that the token resources were exhausted. As a result, service over BGP localifnet tunnel may be abnormal. 48: The discriminator configured for an SBFD IPv6 reflector does not take effect on the board. In order to ensure that the alarm is not suppressed between different services, the alarm suppression time is not set. But the business itself must ensure that the suppression time. 49: Note that Eth-Trunk-based TWAMP Light cannot be implemented on the board in this slot.If being implemented in this slot, TWAMP Light fails to take effect.

Possible Causes

There is a board on the device that does not support the service or if there is a board that does not support the service on the device, when the service is newly configured.

Procedure

The trap is informational only, and no action is required.