MPLS-TE/4/TRAFFIC_RESUME

Message

MPLS-TE/4/TRAFFIC_RESUME: Tunnel traffic resumes from backup hot-standby LSP. (TunnelId=[TunnelId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId],MainLspId=[MainLspId], MainLspPorotolStatus=[MainLspPorotolStatus], MainLspDetectStatus=[MainLspDetectStatus], BackLspId=[BackLspId], BackLspPorotolStatus=[BackLspPorotolStatus], BackLspDetectStatus=[BackLspDetectStatus])

Description

After the BFD session went Up, MPLS TE switched back traffic from the hot-standby LSP to the primary LSP.

Parameters

Parameter Name	Parameter Meaning
TunnelId	Primary tunnel ID
IngressLsrId	IP address of the ingress on the primary tunnel
EgressLsrId	Destination IP address of the primary tunnel
MainLspId	Primary LSP ID
MainLspPorotolStatus	Primary LSP protocol status
MainLspDetectStatus	Primary LSP detection status
BackLspId	Backup LSP ID
BackLspPorotolStatus	Backup LSP protocol status
BackLspDetectStatus	Backup LSP detection status

Possible Causes

The BFD session changed from Down to Up. This event was notified to MPLS TE.

Procedure

This log message is informational only, and no action is required.