MPLS-TE/4/TRAFFIC_SWITCH: Tunnel traffic switches to backup hot-standby LSP. (TunnelId=[TunnelId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId], SetupPriority=[SetupPriority], HoldPriority=[HoldPriority], MainLspId=[MainLspId], MainLspProtocolStatus=[MainLspProtocolStatus], MainLspDetectStatus=[MainLspDetectStatus], BackLspId=[BackLspId], BackLspProtocolStatus=[BackLspProtocolStatus], BackLspDetectStatus=[BackLspDetectStatus], SwitchReason=[SwitchReason])
| Parameter Name | Parameter Meaning |
|---|---|
|
TunnelId |
Primary tunnel ID |
|
IngressLsrId |
IP address of the ingress on the primary tunnel |
|
EgressLsrId |
Destination IP address of the primary tunnel |
|
SetupPriority |
Tunnel setup priority |
|
HoldPriority |
Tunnel hold priority |
|
MainLspId |
Primary LSP ID |
|
MainLspProtocolStatus |
Primary LSP protocol status |
|
MainLspDetectStatus |
Primary LSP detection status |
|
BackLspId |
Backup LSP ID |
|
BackLspProtocolStatus |
Backup LSP protocol status |
|
BackLspDetectStatus |
Backup LSP detection status |
|
SwitchReason |
Switch Reason |
This log message is informational only, and no action is required.