TUNNEL-TE/3/TUNNEL_APS_SWITCHFAIL_active

Message

TUNNEL-TE/3/TUNNEL_APS_SWITCHFAIL_active: Tunnel protection group receives an APS switch fail alarm. (IfIndex=[WorkTunnelIfIndex], SessionTunnelId=[SessionTunnelId], LocalLspId=[LocalLspId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId],WorkTunnel=[WorkTunnel], SignalingProtocol=[SgnlPrtcl], SignalledTunnelName=[SignalledTunnelName])

Description

A alarm was generated when tunnel protection group receives an APS switch fail.

Parameters

Parameter Name	Parameter Meaning
WorkTunnelIfIndex	Work Tunnel Interface Index
SessionTunnelId	Tunnel ID of a session
LocalLspId	LSP ID of a tunnel session
IngressLsrId	LSR ID of the ingress of a tunnel
EgressLsrId	LSR ID of the egress of a tunnel
WorkTunnel	Name of the working tunnel in a tunnel protection group
SgnlPrtcl	Signaling protocol used by a tunnel session Range of value: 1: RSVP Type 2: STATIC Type 3: CRSTATIC Type
SignalledTunnelName	Tunnel alias.

Possible Causes

The configuration of the APS protection group is inconsistent at the two ends.

Procedure

1. Check whether the configuration is consistent at the two ends of the APS protection group.

If the configuration is inconsistent, modify the configuration of the APS protection group so that the configuration at the two ends is consistent.
If the configuration is consistent, go to Step 2.

2. Deactivate and reactivate the APS protection at the two ends.