PM/4/EVT_PER_REP_UAT_NEW

Message

PM/4/EVT_PER_REP_UAT_NEW: The event starts at [StartTime], stops at [EndTime], and event state is [EventState] (InstanceTypeName=[InstanceTypeName], InstanceTypeId=[InstanceTypeId], InstanceName=[InstanceName], MeasureId=[MeasureId], MeasureName=[MeasureName]).

In VS mode, this log is supported only by the admin VS.

Description

UAT event information.

Parameters

Parameter Name	Parameter Meaning
StartTime	Event start time
EndTime	Event end time
EventState	Event status
InstanceTypeName	Name of a statistical type
InstanceTypeId	ID of a statistical type
InstanceName	Name of a statistical instance
MeasureId	ID of a statistical indicator
MeasureName	Name of a statistical indicator

Possible Causes

Cause 1: The UAT event was generated when 10 SESs continuously occurred.

Cause 2: The UAT event was cleared when 10 non-SESs continuously occurred.

Procedure

Cause 1: The UAT event was generated when 10 SESs continuously occurred.

1. Check whether link signals are of poor quality. Replace the fiber or clean the optical module. Check whether the event is cleared.

If the event is cleared, the log message is informational only, and no action is required.
If the event is not cleared, go to 2.

2. Collect log information and configuration information, and then contact technical support personnel.

Cause 2: The UAT event was cleared when 10 non-SESs continuously occurred.
This log message is informational only, and no action is required.