NAT/4/hwCGNUserPortUseUpAlarm_active

Message

NAT/4/hwCGNUserPortUseUpAlarm_active: The number of ports is used up. (Protocol=[Protocol], CPEIP=[CPEIP], InstanceType=[InstanceType], InstanceName=[InstanceName], AddrGroupName=[AddrGroupName], Threshold=[Threshold], Ports=[Ports], Slot=[Slot], Cpu=[Cpu], UserID=[UserID])

This log is supported only on NetEngine 8000 F1A.

In VS mode, this log is supported only by the admin VS.

Description

User-based ports are used up.

Parameters

Parameter Name	Parameter Meaning
Protocol	Protocol type. The value is TOTAL.
CPEIP	CPE IP address.
InstanceType	Instance type.
InstanceName	Instance name.
AddrGroupName	Name of an IP address pool.
Threshold	Threshold of the proportion of CGN interfaces assigned to users to the total supported ones.
Ports	Number of used ports.
Slot	Slot ID of a service board.
Cpu	CPU ID of the service board.
UserID	User ID.

Possible Causes

The number of user ports is used up.

Procedure

Collect alarm, log, and configuration information, and contact technical support engineers.