PIC/1/hwCardFail_clear

Message

PIC/1/hwCardFail_clear: The card resumed from partial failure. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityType=[EntityType], EntityTrapFaultID=[EntityTrapFaultID], Reason=[Reason])

In VS mode, this log is supported only by the admin VS.

Parameters

Parameter Name	Parameter Meaning
EntityPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalName	Indicates the name of the physical entity.
EntityType	Indicates the type of the physical entity.
EntityTrapFaultID	Indicates the error code.
Reason	Indicates the description of the cause of the trap.

Possible Causes

Cause 132140:The voltage became normal.
Cause 132142:The voltage became normal.
Cause 135168:Subcard monitoring channel failure recovery.
Cause 135170:Subcard sensor failure recovery.
Cause 135180:The chip became normal.
Cause 135195:Fault with interface MAC CRC error on a subcard is rectified.
Cause 135196:Fault with e-label CRC error on a subcard is rectified.
Cause 135197:Voltage drop recovery.
Cause 135198:EEPROM is normal.

Procedure

This trap message is informational only, and no action is required.