DEVM/1/hwChassisFail_active-131348

Message

DEVM/1/hwChassisFail_active: The chassis failed partially. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityTrapFaultID=131348, Reason=Device power is insufficient.)

This log is supported only on NetEngine 8000 F1A.

In VS mode, this log is supported only by the admin VS.

Description

The chassis experienced a partial failure.

Parameters

Parameter Name	Parameter Meaning
EntityPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalName	Indicates the name of the physical entity, such as chassis.
EntityTrapFaultID	Indicates the error code.
ReasonDescription	Indicates the description of the cause of the trap.

Possible Causes

Device power is insufficient.

Procedure

1. Check whether enough power modules are installed as required.

If yes, go to Step 3.
If no, go to Step 2.

2. Install enough power modules as required.

If the alarm is cleared, go to Step 4.
If the alarm persists, go to Step 3.

3. Collect trap, log, and configuration information, and contact technical support.

4. End.