CLKM/4/hwClockGnssModelChange

Message

CLKM/4/hwClockGnssModelChange: Switches the mode of the smart clock module. (hwClockPortIfIndex=[hwClockPortIfIndex], hwClockPortName=[hwClockPortName], hwClockGnssModel=[hwClockGnssModel], hwClockOldGnssModel=[hwClockOldGnssModel])

In VS mode, this log is supported only by the admin VS.

Description

Module mode change notification.

Parameters

Parameter Name	Parameter Meaning
hwClockPortIfIndex	Index of the port whose working mode is changed.
hwClockPortName	Name of the port whose working mode is changed.
hwClockGnssModel	New working mode. The value can be: gps(1) glonass(2) beidou(3) gps-glonass(4) gps-beidou(5)
hwClockOldGnssModel	Old working mode of the port. The value can be: gps(1) glonass(2) beidou(3) gps-glonass(4) gps-beidou(5)

Possible Causes

Cause 1: The user manually changed the configuration to switch the GNSS mode.

Cause 2: The mode of the module is automatically switched based on the priority.

Procedure

1. Run the display smart-clock command to check the current working mode and the number of working modes.

If the RAT information is consistent with that in the reported log, the log is reported normally. In this case, go to Step 3.
If the RAT is inconsistent with that in the reported log, go to Step 2.

2. Collect trap, log, and configuration information, and contact technical support.

3. End.