EMDI/4/hwEmdiOutRtpSerOverThreshold_active

Message

EMDI/4/hwEmdiOutRtpSerOverThreshold_active: The outbound RTP-SER of the channel exceeds the threshold. (ChannelName=[hwEmdiChannelName], ChannelSourceAddress=[hwEmdiChannelSourceAddress], ChannelGroupAddress=[hwEmdiChannelGroupAddress], RtpSerThreshold=[hwEmdiRtpSerThreshold], RtpSer=[hwEmdiRtpSerValue], Slot=[hwEmdiChannelSlot], Interface=[hwEmdiChannelInterface])

This log is supported only on NetEngine 8000 F1A.

In VS mode, this log is supported only by the admin VS.

Description

The outbound RTP-SER of the channel exceeds the threshold.

Parameters

Parameter Name	Parameter Meaning
hwEmdiChannelName	Channel name.
hwEmdiChannelSourceAddress	Channel source address.
hwEmdiChannelGroupAddress	Channel group address.
hwEmdiRtpSerThreshold	Current RTP-SER threshold of a channel.
hwEmdiRtpSerValue	Current RTP-SER value.
hwEmdiChannelSlot	Slot ID.
hwEmdiChannelInterface	Interface Name.

Possible Causes

The disordered rate of outbound packets in channel was too large.

Procedure

1.According to the eMDI statistical information to confirm the fault equipment. (eMDI does not differentiate upstream and downstream traffic. eMDI needs to globally analyze fault points on the entire network based on information about each detection point.)

2.Replace optical modules or optical fibers of faulty equipment. Then check whether the trap is cleared.

If the trap is cleared, go to Step 4.
If the trap persists, go to Step 3.

3.Collect trap, log, and configuration information, and then contact technical support personnel.

4.End.