EMDI/4/hwEmdiRtpLrOverThreshold_active

Message

EMDI/4/hwEmdiRtpLrOverThreshold_active: Channel RTP-LR exceeds the threshold. (ChannelName=[hwEmdiChannelName], ChannelSourceAddress=[hwEmdiChannelSourceAddress], ChannelGroupAddress=[hwEmdiChannelGroupAddress], RtpLrThreshold=[hwEmdiRtpLrThreshold], RtpLr=[hwEmdiRtpLrValue])

This log is supported only on NetEngine 8000 F1A.

In VS mode, this log is supported only by the admin VS.

Description

The channel RTP-LR exceeded the threshold.

Parameters

Parameter Name	Parameter Meaning
hwEmdiChannelName	Channel name.
hwEmdiChannelSourceAddress	Channel source address.
hwEmdiChannelGroupAddress	Channel group address.
hwEmdiRtpLrThreshold	Current RTP-LR threshold of a channel.
hwEmdiRtpLrValue	Current RTP-LR value.

Possible Causes

A large number of channel packets were lost.

Procedure

1.According to the eMDI statistical information to confirm the fault equipment. (eMDI does not differentiate upstream and downstream traffic. eMDI needs to globally analyze fault points on the entire network based on information about each detection point.)

2.Replace optical modules or optical fibers of faulty equipment. Then check whether the trap is cleared.

If the trap is cleared, go to Step 4.
If the trap persists, go to Step 3.

3.Collect trap, log, and configuration information, and then contact technical support personnel.

4.End.