DEVM/1/hwEntityInvalid_active: Physical entity failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=[67633], BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=Cause 1: An internal submodule was not properly installed. Cause 2: An internal submodule failed.)
In VS mode, this log is supported only by the admin VS.
| Parameter Name | Parameter Meaning |
|---|---|
|
BaseTrapSeverity |
To describe the level of trap. |
|
ProbableCause |
To describe the probable cause of trap. |
|
BaseTrapEventType |
To describe the type of trap. |
|
EntityPhysicalIndex |
The index of the physical entity. |
|
EntContainedIn |
The value of entPhysicalIndex for the physical entity. |
|
EntPhysicalName |
The textual name of the physical entity. |
|
RelativeResource |
This object may contain a key word to indicate the relative resource of an entity. |
|
ReasonDescription |
To describe the reason of trap in DisplayString style. |
Cause 1: An internal submodule was not properly installed.
Cause 2: An internal submodule failed.
1. Check whether the power module is correctly installed.
2. Remove and reinstall the power module and check whether the alarm is cleared.
3. Perform an active/standby switchover and check whether the alarm is cleared.
4. Replace the power module. Power off the faulty power module before replacing it. Then, check whether the alarm is cleared.
5. Collect trap, log, and configuration information, and contact technical support.
6. End.