DEVM/1/hwEntityInvalid_active: Physical entity failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=[67661], BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=The signal carrying the slot information sent from the MPU to the interface board was abnormal.)
In VS mode, this log is supported only by the admin VS.
| Parameter Name | Parameter Meaning |
|---|---|
|
BaseTrapSeverity |
To describe the level of trap. |
|
ProbableCause |
To describe the probable cause of trap. |
|
BaseTrapEventType |
To describe the type of trap. |
|
EntityPhysicalIndex |
The index of the physical entity. |
|
EntContainedIn |
The value of entPhysicalIndex for the physical entity. |
|
EntPhysicalName |
The textual name of the physical entity. |
|
RelativeResource |
This object may contain a key word to indicate the relative resource of an entity. |
|
ReasonDescription |
To describe the reason of trap in DisplayString style. |
The signal carrying the slot information sent from the MPU to the interface board was abnormal.
1. Run the reset slot slot-id command to reset the faulty board and then check whether the board can be normally registered.
2. Replace the faulty interface board and check whether the alarm is cleared.
3. Collect trap, log, and configuration information, and contact technical support.
4. End.