DEVM/1/hwEntityInvalid_active: Physical entity failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=[67765], BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=Cause 1: The software of the board is faulty. Cause 2: The hardware of the TCAM is faulty.)
In VS mode, this log is supported only by the admin VS.
| Parameter Name | Parameter Meaning |
|---|---|
|
BaseTrapSeverity |
To describe the level of trap. |
|
ProbableCause |
To describe the probable cause of trap. |
|
BaseTrapEventType |
To describe the type of trap. |
|
EntityPhysicalIndex |
The index of the physical entity. |
|
EntContainedIn |
The value of entPhysicalIndex for the physical entity. |
|
EntPhysicalName |
The textual name of the physical entity. |
|
RelativeResource |
This object may contain a key word to indicate the relative resource of an entity. |
|
ReasonDescription |
To describe the reason of trap in DisplayString style. |
Cause 1: The software of the board is faulty.
Cause 2: The hardware of the TCAM is faulty.
1. Upgrade the system software or install a patch on the faulty board.
2. Run the display device command to check whether the faulty board is registered successfully. Then, check whether the alarm is cleared.
3. Replace the board and then check whether the alarm is cleared.
4. Collect trap, log, and configuration information, and contact technical support.
5. End.