DEVM/1/hwEntityInvalid_active: Physical entity failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=[67771], BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=Cause 1:The EPLD logic file was faulty. Cause 2: The EPLD hardware was faulty. Cause 3: The EPLD version is different from that of the system.)
In VS mode, this log is supported only by the admin VS.
| Parameter Name | Parameter Meaning |
|---|---|
|
BaseTrapSeverity |
To describe the level of trap. |
|
ProbableCause |
To describe the probable cause of trap. |
|
BaseTrapEventType |
To describe the type of trap. |
|
EntityPhysicalIndex |
The index of the physical entity. |
|
EntContainedIn |
The value of entPhysicalIndex for the physical entity. |
|
EntPhysicalName |
The textual name of the physical entity. |
|
RelativeResource |
This object may contain a key word to indicate the relative resource of an entity. |
|
ReasonDescription |
To describe the reason of trap in DisplayString style. |
Cause 1:The EPLD logic file was faulty.
Cause 2: The EPLD hardware was faulty.
Cause 3: The EPLD version is different from that of the system.
1. Run the corresponding command to upgrade the board EPLD by board type in the diagnostic view. After the upgrade is finished and the board is registered, check whether the alarm is cleared.
2. Replace the board and then check whether the alarm is cleared.
3. Collect trap, log, and configuration information, and contact technical support.
4. End.