DEVM/1/hwEntityInvalid_active-68040

Message

DEVM/1/hwEntityInvalid_active: Physical entity failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=[68040], BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=The FPGA fault was detected on the PIC card.)

In VS mode, this log is supported only by the admin VS.

Description

Physical entity failed.

Parameters

Parameter Name	Parameter Meaning
BaseTrapSeverity	To describe the level of trap.
ProbableCause	To describe the probable cause of trap.
BaseTrapEventType	To describe the type of trap.
EntityPhysicalIndex	The index of the physical entity.
EntContainedIn	The value of entPhysicalIndex for the physical entity.
EntPhysicalName	The textual name of the physical entity.
RelativeResource	This object may contain a key word to indicate the relative resource of an entity.
ReasonDescription	To describe the reason of trap in DisplayString style.

Possible Causes

The FPGA fault was detected on the PIC card.

Procedure

1. Check whether the faulty board is an FPIC.

If so, go to Step 3.
If not, go to Step 2.

2. Run the reset slot slotID card cardID command to reset the FPIC, and then check whether the alarm is cleared.

If so, go to Step 6.
If not, go to Step 3.

3. Run the reset slot slotID command to reset the faulty board and then check whether the board can function properly.

If so, go to Step 6.
If not, go to Step 4.

4. Replace the faulty board. After the new board is registered, check whether the alarm is cleared.

If so, go to Step 6.
If not, go to Step 5.

5. Collect trap, log, and configuration information, and contact technical support.

6. End.