DEVM/1/hwEntityInvalid_active: Physical entity failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=[68049], BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=The BSP module detected a fault on the key chip EEPROM or IIC bus on a board.)
In VS mode, this log is supported only by the admin VS.
| Parameter Name | Parameter Meaning |
|---|---|
|
BaseTrapSeverity |
To describe the level of trap. |
|
ProbableCause |
To describe the probable cause of trap. |
|
BaseTrapEventType |
To describe the type of trap. |
|
EntityPhysicalIndex |
The index of the physical entity. |
|
EntContainedIn |
The value of entPhysicalIndex for the physical entity. |
|
EntPhysicalName |
The textual name of the physical entity. |
|
RelativeResource |
This object may contain a key word to indicate the relative resource of an entity. |
|
ReasonDescription |
To describe the reason of trap in DisplayString style. |
1. Run the reset slot command to reset the faulty board. Then, check whether the board can function properly.
2. Collect trap, log, and configuration information, and contact technical support.
3. End.