DEVM/1/hwEntityInvalid_active: Physical entity failed. (BaseTrapSeverity=[BaseTrapSeverity], BaseTrapProbableCause=[68060], BaseTrapEventType=[BaseTrapEventType], EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalContainedIn=[EntContainedIn], EntPhysicalName=[EntPhysicalName], RelativeResource=[RelativeResource], ReasonDescription=The fault in the key chip of the PIC card was detected.)
In VS mode, this log is supported only by the admin VS.
| Parameter Name | Parameter Meaning |
|---|---|
|
BaseTrapSeverity |
To describe the level of trap. |
|
ProbableCause |
To describe the probable cause of trap. |
|
BaseTrapEventType |
To describe the type of trap. |
|
EntityPhysicalIndex |
The index of the physical entity. |
|
EntContainedIn |
The value of entPhysicalIndex for the physical entity. |
|
EntPhysicalName |
The textual name of the physical entity. |
|
RelativeResource |
This object may contain a key word to indicate the relative resource of an entity. |
|
ReasonDescription |
To describe the reason of trap in DisplayString style. |
1. Check whether the faulty board is an FPIC.
2. Run the reset slot slotID card cardID command to reset the FPIC, and then check whether the alarm is cleared.
3. Run the reset slot slotID command to reset the faulty board and then check whether the board can function properly.
4. Replace the faulty board. After the new board is registered, check whether the alarm is cleared.
5. Collect trap, log, and configuration information, and contact technical support.
6. End.