L2VPN/2/hwL2vpnOamCsf_active

Message

L2VPN/2/hwL2vpnOamCsf_active: OAM reported an alarm about a client signal failure. (ServiceType=[ServiceType], ProtocolType=[ProtocolType], VcID=[VcID], VcType=[VcType], PeerAddr=[PeerAddr], IfIndex=[IfIndex], PwMaster=[PwMaster], RmtSiteID=[RmtSiteID], InLabel=[InLabel], OutLabel=[OutLabel], IfName=[IfName], VsiName=[VsiName])

Description

OAM detected a client signal failure.

Parameters

Parameter Name	Parameter Meaning
ServiceType	Type of the service: 0: VPWS. 1: VPLS.
ProtocolType	Type of the protocol: 0: SVC. 1: LDP. 2: BGP (not supported for the time being).
VcID	VC ID.
VcType	VC type.
PeerAddr	IP address of the peer.
IfIndex	Interface index.
PwMaster	PW identifier: 1: primary PW. 2: secondary PW.
RmtSiteID	Remote site ID.
InLabel	VC in-label.
OutLabel	VC out-label.
IfName	Interface name.
VsiName	VSI name.

Possible Causes

The local end detected a client signal failure and sent a CSF OAM packet to notify the remote end of the failure.

Procedure

1. Run the display current-configuration command to check whether the AC link is shut down.

If the link is shut down, go to Step 2.
If the link is not shut down, go to Step 3.

2. Run the undo shutdown command and check whether the AC link goes Up.

If the link goes Up, go to Step 4.
If the link is still Down, go to Step 3.

3. Collect alarm information and configuration information, and then contact technical support personnel.

4. End.