L2VPN/3/hwL2vpnOamSd2Near_active: The OAM module reported an alarm, indicating that the near-end packet loss ratio exceeded the sd2 threshold. (ServiceType=[ServiceType], ProtocolType=[ProtocolType], VcID=[VcID], VcType=[VcType], PeerAddr=[PeerAddr], IfIndex=[IfIndex], PwMaster=[PwMaster], RmtSiteID=[RmtSiteID], InLabel=[InLabel], OutLabel=[OutLabel], IfName=[IfName], VsiName=[VsiName])
| Parameter Name | Parameter Meaning |
|---|---|
|
ServiceType |
Type of the service: - 0: VLL - 1: VPLS |
|
ProtocolType |
Type of the protocol: - 0: SVC - 1: LDP - 2: BGP (not supported for the time being) |
|
VcID |
VC ID |
|
VcType |
VC type |
|
PeerAddr |
IP address of the peer |
|
IfIndex |
Interface index |
|
PwMaster |
PW identifier: - 1: primary PW - 2: secondary PW |
|
RmtSiteID |
Remote site ID |
|
InLabel |
VC in-label |
|
OutLabel |
VC out-label |
|
IfName |
Interface name |
|
VsiName |
VSI name |
1. Perform the troubleshooting operations described in hwMplsTpOamNearDualLossSD2 to rectify the fault. Then, check whether the alarm is cleared.
2. Collect alarm information and configuration information, and then contact technical support personnel.
3. End.