FEI_TPOAM/3/hwL2vpnOamTunnelNonSupport_active

Message

FEI_TPOAM/3/hwL2vpnOamTunnelNonSupport_active: OAM for PW does not support the current public tunnel. (VcID=[VcID], VcType=[VcType], PeerAddr=[PeerAddr], OamType=[OamType])

This log is supported only on NetEngine 8000 F1A.

Description

OAM for PW does not support the current public tunnel.

Parameters

Parameter Name	Parameter Meaning
VcID	Identifier of the layer 2 virtual circuit.
VcType	VC Type: 1-FR. 2-ATM_AAL5. 3-ATM_CELL_TRANSPORT. 4-VLAN. 5-ETHERNET. 6-HDLC. 7-PPP. 8-CEM. 9-ATM_CELL_VCC. 10-ATM_CELL_VPC. 11-IP_LAYER2_TRANSPORT. 12-ATM_ONE_TO_ONE_VCC_CELL_MODE. 13-ATM_ONE_TO_ONE_VPC_CELL_MODE. 14-ATM_AAL5_PDU_VCC_TRANSPORT. 15-FR_PORT. 16-CEP. 17-SAT_E1_OVER_PACKET. 18-SAT_T1_OVER_PACKET. 19-SAT_E3_OVER_PACKET. 20-SAT_T3_OVER_PACKET. 21-CESOPSN_BASIC_MODE. 22-TDMOIP_AAL1. 23-CESOPSN_TDM. 24-TDMOIP_AAL2. 25-FR_DLCI. 26-INTERWORKING. 27-VPLS. 64-IP_INTERWORKING.
PeerAddr	Peer IP address.
OamType	OAM Type: 1-MPLS OAM. 2-MPLS-TP OAM.

Possible Causes

MPLS OAM or MPLS-TP OAM does not support the current public tunnel of PW.

Procedure

1.Check the public tunnel type of PW.

If the tunnel type is TE, go to Step 3.

If the tunnel type is not TE, go to Step 2.

2.Change the public tunnel of PW to a TE tunnel.

If the alarm is cleared, go to Step 4.

If the alarm is not cleared, go to Step 3.

3.Collect alarm information, log information and configuration information, and then contact Huawei technical support personnel.

4.End.